![]() ![]() Scale converter : calculate the actual length and the scale length according to the scale ratio. ![]() Height conversion : convert feet and inches to centimeters, convert cm to ft and in.Feet to CM : convert feet(ft) to centimeters(cm), or centimeters to feet.MM to CM : convert millimeters(mm) to centimeters(cm), or centimeters to millimeters.Inches to feet : convert inches(in) to feet(ft), or feet to inches.Inches to CM : convert inches(in) to centimeters(cm), or centimeters to inches.I google the PPI reference and found 100 PPI to my screen, after i measure the size of virtual ruler by a actual ruler, i found the markings are not very accurate at 30cm, so i set the default pixels per inch. The diagonal screen is 15.6'(inches) of my laptop computer, resolution is 1366x768 pixels. Online scale ruler with metric units(cm, m, km) Adjusting this virtual ruler to actual size. Online scale ruler with imperial units(in, ft, yd, mi) It's a good idea to check the products size, before we buying it from internet, try this virtual actural size ruler One centimeter is approximately three times smaller than an inch. Another way to imagine the size of a centimeter is in relation to inches. Most Fractional Rulers are based on the English measuring system where scales are graduated in units of one inch and fractions of an inch.Ī centimeter is 10 millimeters, or approximately the width of a fingernail. If you have more than one monitor, you will also have to specify the name of the monitor via -output. Using your ruler, you can calculate the actual dots per inch and tell the X system what that is: xrandr -dpi 200. Decimal Rulers have graduations or marks which are based on the decimal system such as 0.5, 0.25, 0.1, 0.05, etc. The physical size of the monitor determined by the X system is the total dots divided by the dots per inch. Fractional Rulers have graduations or marks based on fractions, for example 1/2", 1/4" 1/8", 1/16", etc. There are two types of scales commonly used on rulers Fractional and Decimal. 1 meter = 100 centimeters = 1,000 millimeters.Set the pixels per inch (PPI) according your own device. If you would like to have the online ruler in actual size, So i set the default pixels per inch(PPI) is 100.7 for myself. I found the markings are not very accurate at 30cm, I google the PPI reference and found 100 PPI to my screen,Īfter i measure the size of virtual ruler by a actual ruler, The diagonal screen is 15.6"(inches) of my laptop computer, resolution is 1366x768 pixels. Use 1/8" graduations, 10cm = 4" Use 1/16" graduations, 10cm = 3 15/16" Īdjusting this online ruler to actual size.Fill MM, CM, decimal inch or fraction to convert ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |